Oportunidades de Empleo
mexico page
Oportunidades de Empleo

Technical Notes

   
Fanuc Laser Gas Data Sheet

 

AESI Service Department Customer Support -- Tech Note: L004
Applies to: Laser Machines Equipped with Fanuc Lasers.
Last updated: November 16, 1996.


Catalog

The following procedure applies to all Amada Laser Machines equipped with the Fanuc C1000, C1500, C2000, C1500B, C2000A, C2000B or C3000B lasers.

 
Fanuc Laser Gas Data Sheet
Amada Engineering
The following information will help in maintaining your Fanuc Laser. Please make sure that the Laser gas does not go below 200 psi on the primary side of the regulator and purge the laser at least three times when the new bottle is installed. If you are running three shifts a day please purge the Laser at least once every 24 hours. Also note that the chiller temperature should be above 70° F when the Laser is started up in the morning. Please use a new data sheet with each new bottle of gas.

Customer Name:_______________________________________________________

 

CO2
He
N2
Water Vapor
Hydrocarbon
Gas Purity
(5.25% --4.75% )
(40.8%-- 39.2%)
(56.51%-- 53.48%)
< 5ppm
< 1 ppm
99.99%


Week & Date
Power Calibrate
Rf Voltage #1
Rf Current #1
 
Param #15204 for 16L
Dgn # 909 for 16L
Dgn # 910 for 16L
 
Param #241 for 0l
Dgn #861 for 0l
Dgn #862 for 0l
       
 
Record after warm up
Record highest voltage during warm up
Record highest voltage during warm up
 

Copyright© 2026 AMADA DE MÉXICO. Todos Derechos Reservados.