Oportunidades de Empleo
mexico page
Oportunidades de Empleo

 

Technical Notes

 
Parameter loading procedure for 6M

AESI Service Department Customer Support -- Tech Note: P001-6M
Applies to: Fanuc 6M Control.
Last updated: December 27, 1996.
 

SUMMARY

The following procedure applies to the Fanuc 6M Control. It provides step by step instructions for loading parameters. For instructions on editing parameters please go to Editing Parameters

Note 1: If you do not have parameter tapes or disks, you can download them from our Parameter site.

Note 2: In the following explanation bold italic text means it is a push button on the control panel and underlined bold italic text means it is a key switch or toggle switch
 

PROCEDURE

1.
 With the power on, turn the door interlock key, on the back of the control, to OFF.
 
•
 This will allow you to open the door without shuting off the control or shunt breaker.
2.
 Open the front door on the control and turn the Parameter switch to Enable.
 
•
 The switch is located on the Master PC Board in the lower left corner.
 
•
 Alarm 000 will be displayed on the CRT screen.
 
•
 This is just to let you know that the parameters are unprotected and can be over written.
3.
 Select MDI on the mode switch and turn the Edit Protect key OFF.
 
•
 You must be in MDI mode to change any parameters.
4.
 Press the PARAM button on the Control.
 
•
 This will bring up the parameter page.
5.
 Insert the tape in the tape reader.
6.
 Press P-9999 then the READ button.
7.
 After you have finished loading parameters, return the parameter switch to Disable.
 
•
 You will need to turn power OFF and back ON to clear the alarm.
8.
 Test the machine to make sure the new settings are effective and accurate. You may need to edit the parameters if you are using the standard tape. For instructions on editing parameters please go to Editing Parameters
 

Copyright© 2026 AMADA DE MÉXICO. Todos Derechos Reservados.